Rice Lake MSI-7300 Dyna-Link 2 - Manual (Page 32)

 
 




 
5 times
fixed
blinking blinking
blinking
blinking
blinking
blinking
fixed
fixed
fixed
3DVV
9) Press the F2 key to scroll
the number and the F1
key to enter each digit of
the calibration weight.
In this example, we’ll enter 2500
kg on a 5000 kg capacity scale.
Do not push the
F1 key two times
in a row.
To add a decimal point, push the
POWER key while the number is
blinking.
10) When the entire value of the
test weight is displayed and
the weight and link are
stable, press
F1 to finish off
the weight entry. If the
resultant cal value is within
limits, the display will read
PASS.
11) The display now reads
LoAd2. The Dyna-Link
allows multi-point
calibration. If more cal
points are desired (up to
three additional) press
F2
and repeat steps 8-10. If
finished with span points,
go to step 12.
12) Press ZERO to store the
calibration constants. The
LCD will read CAL’d to
indicate the calibration is
acceptable.
13) Skip to step 14, or press F1
to observe the CAL number.
The C-CAL number
appears. Make a note of the
value.
14) Press ZERO to exit
calibration. The next menu
item Setup appears.
15) Press ZERO to store the
calibration and return to
standard link operation, or
press
F1 if you want to
adjust additional cal setup
parameters
(Standard, AZM, etc.)
You can cancel calibration by pressing
Power and the scale will reset to the
previous calibration constants.
To add span
points
Go to step 8
To complete
calibration
63DQ
63DQ
/RDG
6HW8S
Next Cal menu item
SCROLL
F2
SCROLL
F2
SCROLL
F2
SCROLL
F2
SCROLL
F2
SCROLL
F2
F2
SCROLL
ENTER/SELECT
F1
ENTER/SELECT
F1
ENTER/SELECT
F1
ENTER/SELECT
F1
0
EXIT/SAVE
ZERO
0
EXIT/SAVE
ZERO
ENTER/SELECT
F1
Optional:
to display
Cal number
&&D/
ENTER/SELECT
F1

blinking
Example Cal#
VWRUH
0
EXIT/SAVE
ZERO
&$/ '
Cal saved to memory
F1
28 MSI-7300 Operator’s Manual
Figure 5-2 Standard Calibration Procedure (continued)