Rice Lake MSI-7300 Dyna-Link 2 - Manual (Page 48)

12) Press F2 and using the
previous process, enter
the RF channel number.
Recommended RF Channel numbers
range from 12 to 23. In this example
we’ll use 21 as the RF Channel.
13) When the desired RF
channel number is
shown and fixed, press
F1 .
14) The next RF setup menu
item is the nEtid
(Network ID). Press
F1
to see the current net ID
number.
If the offered network ID value is
correct, push
F1 and jump to step 17.
15) Using the numeric entry
process as before, input
a network ID number.
Press
F2 to start a new
number.
Allowed network ID numbers range
from 0 to 99999. MSI recommends
a random number of at least four
digits to ensure that the 8000
system won’t conflict with any
other 802.11.4 networks (Zigbee).
16) When the final number is
shown and fixed, press
F1 to store the network
ID.
17) The RF setup menu goes
to the first menu, OnOff.
Press the
ZERO key to
exit out of the RF setup
menus.
18) Press ZERO again to exit
the COMM setup menu
and store the new RF
network numbers.
QHWLG

 
blinking
blinking fixed

blinking

blinking

fixed

current Net ID blinking

blinking
 
example value only
6WU(Q
SCROLL
F2
SCROLL
F2
SCROLL
F2
SCROLL
F2
SCROLL
F2
ENTER/SELECT
F1
ENTER/SELECT
F1
ENTER/SELECT
F1
ENTER/SELECT
F1
ENTER/SELECT
F1
Repeat number
entry procedure
3ULQW
6WRUH
2Q2II
ENTER/SELECT
F1
0
EXIT/SAVE
ZERO
0
EXIT/SAVE
ZERO

blinking
ENTER/SELECT
F1
17) The menu displays StrEn.
Press the F1 to enter.
Press F2, using the
numeric entry process,
input a transmission
strength number.
16) When the desired number
is displayed, press F1 to
store the number.
18)
When setting
, use the
lowest setting
possible to achieve the
transmission required.
Both the Scale/Dyna-Link
and the 8000 should be
set at the same
transmission strength
setting.
Note
44 MSI-7300 Operator’s Manual
RF Setup Procedure (continued)