Rice Lake MSI-7300 Dyna-Link 2 - Manual (Page 14)

10 MSI-7300 Operator’s Manual
1.7 Options
Options which you may have ordered with your Dyna-Link 2 may include the
following:
• Audible alarm (triggered by setpoint 1)
• Top and bottom shackles
• Portable carry case
• Serial I/O cable (RS-232)
• RF remote display (will also operate hard-wired). See RF remote display for
ScaleCore user guide.
• Hardwired cable for remote display.
• RF remote modem, RS-232, for direct connection to computers, scoreboards, or
serial printers. See RF modem for ScaleCore user guide.
• RF remote modem, USB, for direct connection to computers. See RF modem for
ScaleCore user guide.
• RF remote gateway for direct connection to an Ethernet LAN and for use with
MSI’s SCCMP program. See RF modem for ScaleCore user guide.
• RF or hardwired scoreboard display.
1.8 Unpacking
When unpacking the Dyna-Link 2 from the shipping container, ensure that all
assembly parts are accounted for.
Check for any visible damage and immediately report any damage to your shipper.
Retain the original shipping container for future shipping or transporting.
1.9 Assembly
1. Identify and locate the following:
• Batteries, two ‘C’ cells or ‘D’ cells depending on capacity
• Top shackle and pin (option or customer supplied)
• Bottom shackle and pin (option or customer supplied)
• Two cotter pins
2. Slide top shackle over load cell and insert the pin.
3. Screw the shackle nut onto the pin.
WARNING
Note
Note
It is not necessary or desirable to tighten the nut too tight. Make sure
the nut is down far enough to expose the cotter pin hole.
4. Lock the shackle pin in place with the supplied cotter pin. Bend the cotter pin.
5. Repeat steps 1-3 for the bottom shackle.
6. Remove the battery access port cover with a coin or a large screwdriver.
7. Insert the two batteries, positive end first, into the battery shaft.
8. Reinstall the battery access port cover. The Dyna-Link 2 is now ready for use.
The Dyna-Link2 will automatically start when the batteries are
installed.
The Dyna-Link 2 load train will be unsafe for use if the shackle pins
are not properly secured with cotter pins.