BUCHI KjelSampler K-377 - Manual (Page 112)

6 Operation
112 K-375/376/377 Operation Manual, Version B
If a chiller is connected to the device the cooling
water control will be omitted.
If no chiller is connected the cooling water control
can be set either to manual, with a specific flow
rate, or to automatic. In automatic mode the
temperature of the cooling water is measured and
the volume flow is adjusted depending on the water
temperature.
If a printer is connected to the device (HP PCL ®
-compatible) select the printer port (network or
USB-printer), the paper format and the color mode
(monochrome, CMY or CMYK).
For a network printer in addition the IP address has
to be specified.
NOTE
If no printer is available, you may select Adobe
®
PDF as printer type – the data is then stored as a
pdf-file on a USB stick.
Network
If connected to a network, you can assign a device
name for the device to be recognized within the
network.
The IP address can either be obtained automati-
cally via DHCP (Select
YES), or entered manually
together with the subnet mask.
NOTE
More details regarding the network connection
can be found in the document “Manual – Network
connection K-375”, which can be obtained from
any authorized BUCHI representative.