BUCHI KjelSampler K-377 - Manual (Page 93)

6 Operation
93 K-375/376/377 Operation Manual, Version B
6 .7 .3 Blank Correction
The blank correction can be switched on and off:
HOME  Blank Correction  SETTINGS
ON Blank correction of results is switched on.
OFF Blank correction of results is switched off –
no blank correction at all will be performed.
Within the Blank Correction main screen a list of the latest blanks can be viewed. By adapting the
parameter “Blanks in list” under
SETTINGS it can be determined how many blanks will be shown in
this list:
- Will decrease the number of displayed blanks
by 10.
+ Will increase the number of displayed blanks
by 10.
A maximum number of 90 blanks can be listed.
In general four different possibilities for the determination of the active blank value for the automatic
correction of results are available:
• Blank values can be measured ( type: measured).
• Blank values can be entered manually ( type: manual).
• Blank values can be calculated as mean value of freely selectable measured blanks ( type: mean).
• Blank values can be determined automatically by the system ( type: automatic).
The type and the value of the blank currently used for result correction is always displayed in the
results section of the status view:
SHOW STATUS  RESULTS (See section 6.5.1)
Entering Manual blanks
To enter a blank value manually (e.g. for a blank value that has not been determined with the instru-
ment), proceed as follows:
Enter the Blank Correction screen.
Press SETTINGS.