Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 104)

HI-3010 Filler/Dispenser/IBC 88
Service Manual
4. If the fill is within the target window
and it is the last fill cycle of a fill
sequence, the instrument goes to
Standby and the Standby Display
appears. (See Fig. 7-12)
Other Wait Displays that can appear are as follows:
• Waiting for Motion to settle.
• Waiting for Log Off to expire.
• Waiting for fill/dispense to continue.
FIG. 7-12 WAIT DISPLAY
Underfill /Overfill Alarm
- - - - - ALARM CONDITION - - - - -
FIG. 7-13 UNDERFILL ALARM
FIG. 7-14 OVERFILL ALARM
• OVERFILL ALARM, press the Clear but-
ton to clear the alarm. The Accept the Fill
display appears.(See Fig. 7-15) At this
time you can:
1. Accept the fill by pressing the START
button.
2. Physically remove some of the mate-
rial until it meets the target window
requirements and then press the
START button.
3. The instrument returns to the Waiting
On Display, repeats the motion check,
autozeros, autotares and/or checks the
OK to Fill processes and begins fill
cycle number 2.
FIG. 7-15 ACCEPT FILL DISPLAY
• UNDERFILL ALARM, press the Clear
button to clear the alarm, the Accept the
Fill display appears. At this time you can:
1.
Accept the fill by pressing the START
button.
2. Physically add some of the material
until it meets the target window
requirements and then press the
START button.
3. The instrument returns to the Waiting
On Display, repeats the motion check,
autozeros, autotares and/or checks the
OK to Fill processes and begins fill
cycle number 2.
• If the gain in weight is NOT within the tar-
get window and the JOG function is turned
ON the Filler/Dispenser automatically
does the following:
1. If the out of target window is an
OVERFILL the OVER FILL alarm
appears. Clear the alarm using the
same procedures for the OVERFILL
Alarm in the previous section.
2. If the out of target window is an
UNDER FILL, the Jog ON display
appears.
3. If Jog is off you will get a wait display
until the amount is satisfied.