Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 68)

HI-3010 Filler/Dispenser/IBC 52
Service Manual
FIG. 4-114 INSTRUMENT SETUP/SELECTING THE
DECIMAL POINT POSITION
Step 9. To turn ON the Totalizer click in the On radio but-
ton. To turn OFF the Totalizer click in the OFF
radio button.
Step 10. To set the Total Decimal Point Position:
• Click on the Total Decimal Point pull
down menu. (See Fig. 4-115)
• Click on the Total Decimal Point position
you want for your process.
FIG. 4-115 INSTRUMENT SETUP/SETTING TOTAL
DECIMAL POINT POSITION
Step 11. To set the Motion Tolerance, double click in the
Motion Tolerance field and enter the new Motion
Tolerance parameter.
Step 12. To turn the OK to Fill Input ON, click in the OK to
Fill Input ON radio button. To turn the OK to Fill
Input OFF, click in the OK to Fill Input OFF radio
button.
Step 13. To adjust the OK to Fill Timer, double click in the
OK to Fill Timer field and enter the new time.
Step 14. Click on the Set Parameters button to set the
entries.
Step 15. Click on the right arrow at the bottom of the page to
go to Instrument Setup page 2. (See Fig. 4-116)
FIG. 4-116 INSTRUMENT SETUP/PAGE 2
Step 16. To set the Zero Tolerance, double click in the Zero
Tolerance field and enter a new Zero Tolerance
parameter.
Step 17. To turn ON Use Auto-Zero (Tolerance) click in the
Use Auto-Zero ON radio button. To turn OFF Use
Auto-Zero (Tolerance) click in the Use Auto-Zero
OFF radio button.
Step 18. To set the Auto - Zero Tolerance, double click in the
Auto - Zero Tolerance field and enter a new Auto -
Zero Tolerance parameter.
Step 19. To set the Auto - Zero Time, double click in the
Auto - Zero Time field and enter a new Auto - Zero
Time parameter.
Step 20. To set the Tare Limit, double click in the Tare Limit
field and enter a new Tare Limit parameter.
Step 21. To set WAVERSAVER
®
:
• Click on the WAVERSAVER pull down
menu. (See Fig. 4-117)
• Click on the WAVERSAVER setting you
want for your process.