Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 39)

23 CHAPTER 4
Configuration
Setup/3/DEF Button
This button enables you to access the configuration and
setup menus. Also enters the number 3 and the letters D, E,
F.
Amount/4/GHI
Enables you to change the amount of the ingredient while in
the standby mode. Also enters the number 4 and the letters
C, H, I.
Units/5/JKL Button
Enables you to change the units of measure (Lbs/Kg/oz/g)
while in the standby mode of operation. Also enters the inte-
ger 5 and the letters J, K, L.
6/MNO Button
Enters the integer 6 and the letters M, N, O.
Cycle/7/PQRS Button
Enables you to change the number of cycles (fills or dis-
penses) while in the standby mode. Also enters the integer 7
and letters P, Q, R, S.
8/TUV Button
Enters the integer 8 and the letters T, U, V.
Test/9/WXYZ Button
Enables you to enter the selftest or diagnostics mode. Also
enters the integer 9 and letters W, X, Y, Z.
User/-/_/@/blank/,/. Button
Enables you to change the 3 digit user code while in the
standby mode. Also enters a dash (-) underscore (_) at (@),
comma (,) and period (.) symbols.
0/(/)/*/+/#/&/’ Button
Enables you to enter the left side of a parentheses (, enter the
right side of a parentheses), asterisk(*), plus sign (+), amper-
sand (&), apostrophe (‘) and the integer 0.
NOTE: Whenever you see --> arrow in a menu it means
that there is a sub-menu that you need to go to in
order to set the parameters.
Selecting Configuration Menus
When the Filler/Dispenser first starts up, the function selec-
tion display appears. (See fig. 4-5)
FIG. 4-5 WELCOME DISPLAY
Step 1. Press the Enter button. The Instrument Selection
screen displays. (See Fig. 4-6)
FIG. 4-6 INSTRUMENT SELECTION SCREEN WITH
FILLER SELECTED (DEFAULT)
Step 2. To move the cursor up and down press the up and
down arrows until the cursor is in front of the
instrument you want to select.
Step 3. Press the Enter button. A prompt asking if you are
sure this is the instrument you want appears. (See
Fig. 4-7)
FIG. 4-7 PROMPT CONFIRMING SELECTION
Step 4. If this is the instrument you want to use, press the
Enter button. The Standby Display appears. (See
Fig. 4-8)
FIG. 4-8 STANDBY DISPLAY
Step 5. Press the Setup/3/DEF button once. The Configura-
tion Menu appears with the cursor in front of