Hardy HI 6500 Series - Manual (Page 102)

92 Chapter 5
•
•
•
•
•
•
Operations Parameter Menu
The following parameters are used to setup the instrument operations:
• Tare Operations
o Tare Amount
o Tare Offset
oTare
• Zero Operations
o Zero Tolerance
o Zero Amount
o Zero
• Auto Mode
o Auto Mode Enabled
o Auto Mode Disabled
• Count Operations
o Count Enable
o Unit Weight
o Enable
o Weigh Sample
Tare Operations Commands and Parameters
Tare Amount Parameter
The Tare Amount parameter displays the total amount that has been "Tared" from the scale
minus the Tare Offset.
This value is reset to zero when net and gross are the same weight, and totalizes the
differences each time the Tare command is run. This value excludes the initial Tare Offset
value, which is a constant value subtracted from the Net weight value without the operator
running the Tare command.
Note that on the Web page, the value will appear on the Operations web page under Tare
Operations.