Hardy HI 6500 Series - Manual (Page 21)

Installation 13
•
•
•
•
•
•
Panel Mount Option 1
FIG. 1 Exploded View of the Panel Mount Assembly – Option 1 with optional
mounting kit
Step 1. Screw the Panel Mounting Brackets to the top of the enclosure
Step 2. Connect and hand tighten the four screw rods into the front panel display
Step 3. Push the screw rods and cable assembly though the holes in the panel.
Step 4. Connect the front panel display cable assembly
Step 5. Tighten the four 4mm nuts enough to completely compress the gasket for IP65
Step 6. Position the enclosure with the connectors at the back
Step 7. Align the screw rods with the holes in the brackets and the enclosure
Step 8. Connect the cable assembly
Step 9. Slide the enclosure onto the screw rods until flush with the panel
Step 10. Install and tighten keeper nuts.
CAUTION: Do not over tighten the bracket screws or the mounting nuts as this may damage the
enclosure.
ATTENTION Ne pas trop serrer les écrous de montage car cela pourrait endommager l'enceinte.

