ALTANA LCM IV - Manual (Page 33)

34
Standard programs
6. Press Paper to select the paper size.
Select between:
•
Letter,
• Monarch,
• Executive,
• A4.
7. Press OK to confirm the entry.
Note: Press OK again to return to the "Instrument Setup" menu.
5.2.6.2 Print data
1. In the main menu, press the Recall Data menu option.
2. Select the data source, where the data to be printed are
stored.
A list is displayed. Data can be filtered. Refer to
section 5.3.1.2, page 39 for more information.
3. Press the Send Data symbol to transmit data (table, curve)
directly to the printer.
4. Highlight Single point, Filtered data or All data and press
OK to confirm.
Sending data... appears on the screen until the data is
printed.
5.2.6.3 Print data continuously
If you would like to automatically print out all measured values
immediately after measurement, the use of a continuous form
printer is recommended, for example the 4" paper thermal printer
refer to Section 9, page 107 .
1. Connect the thermal printer to a USB type A port.
2. Press PC and Printer in the "Instrument Setup" menu.
A list with information about the connections opens.
3. Highlight Printer.
4. Press Setup to display the Printer Setup screen.
5. Select Auto-Send: On to send all measured data
automatically to the Thermal printer.