Mopar K6860631 - Manual (Page 107)

5
24. Route the Wi-Fi power harness under the carpet to the
back of the storage bin through the key on power out-
let, slightly pulling back on the storage panel to gain
access.
25. Cut the Wi-Fi power harness to length.
26. Locate the cigarette lighter outlet wiring harness.
27. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
28. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
29. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
30. Place the strands of the power side wires overlapping each
other inside of the splice clip (1).
Aug 08, 2008 K6860631 Rev. 1