Mopar K6860631 User Manual
Page 79
5
23. Remove the two screws (3).
24. Using a trim stick C-4755 or equivalent, separate the
four retaining clips (1) and remove the bezel (2).
25. Disconnect the electrical connectors and remove the
bezel.
26. Route and secure the Wi-Fi harness across the
steering column opening to the center stack and cut
to length.
27. Locate the cigarette lighter outlet wiring harness.
28. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
29. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
30. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
Aug 08, 2008
K6860631 Rev. 1