Mopar K6860631 - Manual (Page 50)

8
WITHOUT FULL CENTER CONSOLE
41. Install the lower IP surround to the vehicle.
42. Connect the power outlet electrical connectors and in-
stall the power outlet trim panel.
43. Close the close out panel by depressing the tab at the
top of the panel.
44. Install the two screws behind the close out and install
the cup holder (2).
45. Install the two lower screws securing the cup holder to
the IP.
46. Install the lower bezel panel (1).
ALL
47. Position the cowl trim panel (1) onto the door sill (3).
48. Push the cowl trim panel forward and then engage the
retaining tabs that secure the sill trim panel to the rear
door sill.
49. Route the seat belt (2) through the slot in the lower
C-pillar trim panel (1) and position the trim panel to
the C-pillar (4).
50. Engage the retaining tabs that secure the lower C-pil-
lar trim panel to the C-pillar.
51. Install the bolt (3) that secures the seat belt to the bot-
tom of the C-pillar. Tighten the bolt to 40 N·m (30 ft.
lbs.).
Aug 08, 2008 K6860631 Rev. 1