Mopar K6860631 - Manual (Page 121)

7
47. Install the load floor panel (1) to the load floor (2). In-
stall the rear seat bracket (3) using hand pressure to
seat the clips.
48. Return the rear seats in the upright position.
49. Align and install the B-pillar trim panel clips (3) rear-
ward and into the quarter trim panel.
50. Push the trim panel (2) down into the body (4) using
hand pressure until all clips are seated.
51. Align and install the trim panel to the body slots (1) on
the B-pillar. Snap into place using hand pressure.
52. Feed the seatbelt webbing through the B-pillar trim (2).
Slide the belt adjuster to the top position.
53. Install the trim by sliding down and into the B-pillar
lower trim.
54. Align the 4-way locator and seat the B-pillar trim to the
body.
55. Install the screw and screw cover.
56. Position the seat back to its original position.
CAUTION: When installing the cowl trim cover make sure not to damage the body plugs, around the sill area. If
damage occurs to the body plugs, replace with new plugs. Failure to replace a damaged body plug results in a
water leak to the floor area of the vehicle.
Aug 08, 2008
K6860631 Rev. 1