Mopar K6860631 User Manual
Page 89
4
7.
Remove the two screws (2) and remove the bezel (1).
8.
Disconnect the electrical connectors and remove the
bezel.
9.
Install and secure the Wi-Fi router under the passen-
ger seat with the materials provided.
10. Cut a small slice in the carpet under the passenger
seat.
11. Route the Wi-Fi power harness under the carpet
through the slice and connect to the Wi-Fi router.
12. Route the wire under the carpet along the sill scuff
area, securing where necessary.
13. Route and secure the Wi-Fi power harness to the in-
strument panel center bezel.
14. Locate the cigarette lighter outlet wiring harness.
15. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
16. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
17. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
Aug 08, 2008
K6860631 Rev. 1