Mopar K6860631 - Manual (Page 67)

2
11. Remove the cowl trim panel (1).
12. Lower the glove box by depressing the two tabs at the
top of the glove box and lowering the glove box.
13. Remove the glove box.
14. Remove the sound insulator from the passenger side
lower instrument panel.
15. Using a trim stick or equivalent, carefully remove the
center bezel and disconnect the electrical connectors.
16. Route and secure the Wi-Fi router harness under the
carpet at the passenger door sill, under the floor duct
and through the opening in the floor carpet.
17. Ensure there is approximately eight inches of harness
sticking out of the floor carpet to allow connection to
the router.
18. Route and secure the Wi-Fi power harness from the
door sill, along the passenger side under the glove box
opening and behind the center stack and cut the Wi-Fi
power harness to the proper length.
19. Locate the cigarette lighter outlet wiring harness.
20. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
21. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
22. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
Aug 08, 2008 K6860631 Rev. 1