Mopar K6860631 - Manual (Page 23)

9
44. Center the heat shrink tubing (2) over the solder joint and
heat using a heat gun. Heat the joint until the tubing is
tightly sealed and sealant (1) comes out of both ends of
the tubing.
45. Engage the retaining tabs of the sill trim panel (1) re-
tainer clips in the rear door sill (2) and install the sill
trim panel.
46. Route the seat belt (2) through the slot in the lower
C-pillar trim panel (1) and position the trim panel to
the C-pillar (4).
47. Engage the retaining tabs that secure the lower C-pil-
lar trim panel to the C-pillar.
48. Install the bolt (3) that secures the seat belt to the bot-
tom of the C-pillar. Tighten the bolt to 40 N·m (30 ft.
lbs.).
Aug 08, 2008 K6860631Rev. 1