Mopar K6860631 - Manual (Page 7)

6
28. Remove the utility hooks (3) from the rear cab trim
panel (1) and remove the trim panel.
29. Install the Wi-Fi router to the rear cab trim panel with
the provided materials.
30. Make a small cut in the rear cab trim panel and route
the Wi-Fi router connector through
31. Place the rear cab trim panel into position in the vehi-
cle.
32. Connect the wire harness to the Wi-Fi router connec-
tor.
33. Route the wire harness down the back of the rear
panel to the door sill.
34. Firmly seat the rear panel and install the utility hooks
to the rear panel.
35. Continue to route the wire harness along the passen-
ger side, under the glove box opening and behind the
center stack.
36. Locate the cigarette lighter outlet wiring harness.
37. Cut each wire and remove 13 mm (0.5 in.) of insula-
tion from each wire that needs to be soldered/spliced.
38. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
39. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
Aug 08, 2008 K6860631 Rev. 1