Mopar K6860631 - Manual (Page 135)

6
38. Center the heat shrink tubing (2) over the solder joint
and heat using a heat gun. Heat the joint until the tub-
ing is tightly sealed and sealant (1) comes out of both
ends of the tubing.
39. Connect the electrical connector to the cigarette
lighter outlet and firmly seat the outlet to the shifter
housing.
40. Install the trim ring (5) onto the shifter console (6) and
seat fully.
41. Install the screws (2).
42. Install the bezel (4) onto the trim ring (5) and seat fully.
43. Install the shift knob (3) onto the shifter (1) and seat
fully.
44. Install the lower steering column cover.
Aug 08, 2008 K6860631 Rev. 1