Mopar K6860631 - Manual (Page 146)

5
20. Route the Wi-Fi power harness (1) under carpet to the
front center console (2) and cut to length.
21. Locate the cigarette lighter outlet wiring harness.
22. Cut each wire and remove 13mm (0.5 in.) of insulation
from each wire that needs to be soldered/spliced.
23. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol-
dered area.
CAUTION: Do not use acid core solder.
24. Solder the supplied fused pigtail to Wi-Fi power har-
ness power wire.
25. Place the strands of the power side wires overlapping each
other inside of the splice clip (1).
Aug 08, 2008 K6860631 Rev. 1