Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 170)

Appendix A: Device Settings
162 TruVision Navigator 5.0 Service Pack 3 User Manual
Feature Support Notes
How to configure
the TVN40 To configure the TVN40 right-click on
the device in the Navigator panel and
select Configure Device.
The TVN40 Configuration dialog will
open.
There are 4 tabs on this Configuration
Form: Network, Recording, Alarm, and
System.
The dialog will store your changes as
you toggle from one tab to another.
Please make all of your configurations
on the tabs first and then click Save
once. This will save you time by sending
all of the changes at one time to the unit.
The Network Tab IP Address - This field is un-editable and
represents the IP Address of the TVN40
itself. If this IP Address needs to be
changed, please delete the TVN40
(right-click and select Delete Device)
and re- add it in TruVision Navigator
with the new IP address.
NTP Server Address - THIS IS A
MANDATORY FIELD! After you have
activated the TruVision Navigator
Server’s NTP Service, enter the IP
Address of the TruVision Navigator
Server here. See the TruVision
Navigator User Manual on NTP for more
information.
MTU Size - This is the Maximum
Transmission Unit setting which defines
the data size of the packets pushed over
the network. Check with your IT
Department to see if they have network
limitations on packet size and adjust
accordingly.
Tunnel Port - This is the sole port used
for communication, command and
control, and video transmission between
TruVision Navigator and the TVN40.
3000 is the default but it can be edited
here.