Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 83)

Chapter 4: TruVision Navigator Settings
TruVision Navigator 5.0 Service Pack 3 User Manual 75
Enable/Disable Controller Playback
controls including Go To, Playback, Live,
double-click on timeline)
Enable/Disable notifications in Notifier
dialog.
Watch Video HBW Enable/Disable Stream and Bandwidth
menus in the Controller. Requires at least one of the
Watch Video permissions
(Live or Playback).
Export Video Enable/Disable Local record button in
Controller. Requires both of the Watch
Video permissions (Live and
Playback).
Enable/Disable Snapshot and Video
buttons in the Controller.
Show/Hide Collector Panel.
Show/Hide Tasks Panel (panel may also
be visible due to other permissions).
View Disk Analysis Show/Hide Disk Analysis context menu for
device.
Show/Hide camera row in Disk Analysis
dialog. Requires both of the Watch
Video permissions (Live and
Playback).
Authentication Complexity
TruVision Navigator has three Authentication Complexity standards - Low, Medium, and
High. The default for a new installation is Low. To change the Authentication
Complexity, select a choice from the drop-down and click OK.
All new users to the application will be required to meet the new Authentication
Complexity standard. However, existing users of the application will not be prompted to
change their credentials to meet the new standard once it is changed. Therefore, the
Administrator must reset each of the existing user accounts for the standard to take
effect. This reset will only affect the password for that user – not the username. It is
recommended to set the Authentication Complexity early before any users are created in
the system to avoid having to do resets.
The table below outlines the components of each of these standards.