Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 47)

Chapter 3: Operation
TruVision Navigator 5.0 Service Pack 3 User Manual 39
• Wavelet/Wavejet - This type is based upon Wavelet/Wavejet compression
methodologies. This streaming type cannot be changed and is the default
streaming type for the DVMRe and StoreSafe DVR lines.
• Enter the device's IP Address, or, the DynDNS or EzDDNS URL.
Note: You can add a device using a Domain Name System (DNS) name as well as a
static IP Address. Simply place the DNS name in the IP Address field on the form
.• Enter the device's listen Port. This field is pre-populated with a default value based
upon the type of device you selected. If you changed this port on the device, add that
specific port in this field.
Note: The port number must be added to the device address when using DynDns
with a HTTP port other than port 80 (i.e. mydvr.dyndns.org:2222 if the HTTP port
being used is 2222). When using No-IP instead of DYNDNS, you also need to add
the HTTP port number.
• Enter the Username and Password. This field is only required if the device being
added has been configured to require a username and password.
• Check the Add Device Offline checkbox if you wish to add the device to the
Navigator but you know the device is currently offline.
• Click OK.
Note: You may see an error message stating that your device was added but it has
unsupported firmware. However, you should still be able to view video. See the
supported devices and firmware versions section of this document.
Adding Devices via Discovery Tool
Once Add Via Discovery Tool option is selected, device discovery window will display.
Device discovery window provides a list of available devices in the network. To add
devices to the Navigator, select one or multiple devices from the list and click Add. Your
device should appear under the Device node in the Navigator panel.
Note: Discovery Tool will attempt to add devices by using their default credentials. If the
credentials of a device are previously changed from default values, device is still going
to be added to the device tree, but will be shown as offline. In this case, updated
credentials need to be applied manually by user from the device properties or
configuration menu with a right click on the device.
Once the recorder shows online, expand the device icon to view your cameras. If you
chose to add the device offline via the Add Device Offline checkbox, your device will
appear in the Navigator with a red X on it. You can bring the device online by right-