Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 79)

Chapter 4: TruVision Navigator Settings
TruVision Navigator 5.0 Service Pack 3 User Manual 71
Server Settings
Server tab of Settings Window provides following server settings:
• SMTP Setup
• Permissions Model
• Authentication Complexity
• Instant Replay
• Custom Help Link
• Server URL
• Client Download URL
SMTP Setup
Simple Mail Transfer Protocol (SMTP) is a de facto standard for email transmissions
across the Internet. TruVision Navigator Server can be configured to use an SMTP
server to send automated email messages (with Client Download URL, Username,
Password) to users when they are created in TruVision Navigator and when their login
credentials (Username, Password) need to be reset in the system by an Administrator. If
SMTP is not setup, this information will need to be delivered via an alternative method
(i.e. phone or personal email).
Enter the SMTP Server IP Address, the port, any username/password credentials that
may be mandated by the SMTP server you are using, and SSL, if necessary. Test this
setup by clicking Test and entering the email address of where you want the test
message sent. Check the application status bar for feedback on the test. As well, check
your email to ensure there is a test message from the TruVision Navigator Server
confirming proper setup of the SMTP server.
You should see an email like the one below. After several minutes, if you still have not
received the message, check your Junk Mail folder to see if the email was classified and
stored there.