Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 174)

Appendix A: Device Settings
166 TruVision Navigator 5.0 Service Pack 3 User Manual
Feature Support Notes
How to change the
default
configurations of
the IP Cameras on
the TVN40 If you would like to tweak the default
configurations of the IP Cameras after
they have been added, right-click on the
camera and select Configure Camera.
The Camera Configuration Form will
open in a dialog with 2 tabs - Camera
and Video.
The Camera Tab Edit any of the fields that you previously
entered on the Add Camera form.
Motion Detection - enable motion
detection for the camera with this
checkbox. This is "all or nothing" motion
detection for the cameras field of view.
There is no grid selection to detect
motion for specific areas of the field of
view at this time.
PTZ Control – if this is a PTZ camera,
make the appropriate PTZ settings here.
Ok button - when you are satisfied with
your edits on both the Camera and
Video Tabs, click the OK button to send
the changes to the TVN40.
Cancel button - should you wish to
abandon your changes simply click the
Cancel button.
The form will store your changes as you
toggle from one tab to another. Please
make all of your configurations on the
tabs first and then click OK once. This
will save you time in sending all of the
changes at one time to the unit.