Toa M-9000M2 v.2.00 User Manual
Page 33
33
8.2.1. Paging using the D-001T, D-001R, or 900 series module
When using the D-001T, D-001R, or 900 series module as paging sound source, set the Paging ON/OFF
setting (
) for each input to ON. This will enable the priority level and paging group settings.
When using two or more paging sound sources, priority level can be set. For example, the following system
can be configured in a supermarket, comprising sales area and backroom area. In the sales area, BGM is
normally broadcast and announcement is made using a paging microphone. Also, it is so designed that
emergency broadcasts and paging calls can be made to the whole area using a different paging microphone.
Paging microphone
for emergency
broadcast and
all-call
BGM player
Input channel 1
Paging set to ON
Priority level 1
Input channel 2
Paging set to OFF
Input channel 3
Paging set to ON
Priority level 2
Paging
microphone
for sales area
Emergency
broadcast and
in-store
announcement
BGM broadcast and
in-store paging call
Backroom area
(Output channel 1)
Sales area
(Output channels 2 and 3)
M-9000M2
Power amplifier
[Operation at normal broadcasts]
Normally BGM is broadcast (Input channel 2) in the sales area. When initiating paging with a paging
microphone for sales area (Input channel 3), the paging call goes through, causing BGM volume level to
decrease.
[Operation at emergency broadcasts]
When initiating paging with a paging microphone for emergency broadcast (Input channel 1), the paging call
goes through to the whole area, causing BGM broadcast and in-store paging announcement currently being
made to decrease.
If the emergency broadcast is being made, paging cannot be initiated using a paging microphone for sales
area because it is connected to the input with lower priority level.
[Paging setting example]
Paging settings require to determine which input is to be sent to which output, and the trigger source to
activate the paging calls in addition to the priority level settings.
In this example, set the paging microphone of Input channel 1 so that it is routed to Output channels 1, 2, and
3 (whole area). Likewise, set the paging microphone of Input channel 3 so that it is routed to Output channels
2 and 3 (sales area).
Set the paging trigger to "VOX," control terminals ("C-IN1 - 4" or "C-IN1 - 12" when the C-001T is used), front-
mounted buttons on the ZM-9011, ZM-9013, or ZM-9014, or front-mounted buttons on the ZM-9001 or ZM-
9002 (Busy input must be assigned to C-IN additionally).
In addition, telephone paging with the use of the ZP-001T can be made.
(For details of paging settings, refer to