P.72-b5) – Toa M-9000M2 v.2.00 User Manual
Page 72
72
(B5) Speaker parameter presetting
S P E Q
->
A L L F L A T
Optimum equalization can be automatically set depending on the type of speaker to be used.
Speaker models (with their parameters) cannot be selected until written into the amplifier using the separate
PC software. Up to 10 kinds of speaker models among those listed below can be written into the amplifier.
(For details, refer to the separate setting software instruction manual.)
If this function is not used or the speaker to be used is not included in a speaker list, set "SP EQ" to ALL
FLAT. When the speaker type is selected from the speaker list, the number of bands that can be set on the
next EQ setting screen decreases by the number of bands to be used in the setting performed on this screen.
The number of bands to be used differs depending on the type of speaker.
To perform this setting, select the speaker model from the speaker list and press the Enter key to confirm.
ALL FLAT (default), F-122, F-122 LOWCUT, H-1, H-1 LOWCUT, H-2, H-2 LOWCUT, H-3,
H-3 LOWCUT, HB-1, FB-100, SW FOR F-122 (subwoofer for F-122), SR-S4, HX-5, HX-
5_E LOWCUT, FB-120, F-1522, F-2322, F-2352, F-2852, SR-H2S, SR-H2L, SR-H3S,
SR-H3L, HS-120, HS-150, HS-1200, HS-1500, F-1000 LOWCUT, F-1300 LOWCUT, F-
2000 LOWCUT
Setting Range
ALL FLAT (Default)
GAIN (dB) FREQ (Hz)
Q
0
31.5
1.5
0
63
1.5
0
125
1.5
0
250
1.5
0
500
1.5
0
1 k
1.5
0
2 k
1.5
0
5 k
1.5
0
8 k
1.5
0
16 k
1.5
EQ 01
EQ 02
EQ 03
EQ 04
EQ 05
EQ 06
EQ 07
EQ 08
EQ 09
EQ 10
[Speaker EQ settings]
Note
Settings for the speaker models with LOWCUT indications provide parameters when these speakers are used
in conjunction with subwoofers, presenting low-cut characteristics.