Toa M-9000M2 v.2.00 - Manual (Page 87)

87
C - I N 0 1 -> V O L U P C - I N 0 1 -> V O L D O W N
(C46)
(When the control input function is set to VOLUP) (C47)
(When the control input function is set to VOLDOWN)
C - I N 0 1 - V O L U P-> I N 1 C - I N 0 1 - V O L D O W N-> I N 1
(C48)
Input/Output channel number selection
(VOLUP) (C49)
Input/Output channel number selection
(VOLDOWN)
C - I N 0 1 - V O L U P 0. 5 C - I N 0 1 - V O L D O W N 0. 5
(C50) Volume increasing level setting (C51) Volume decreasing level setting
[When the function is set to VOLUP or VOLDOWN]
Assign the volume-up or volume-down function to the control input.
Closing the control input terminal increases or decreases the volume of the set input or output channel.
Assigning a function to the control input terminal or ZM-9001/9002's control button overwrites the previously
set function on it if there is.
Using the Input channel or Output channel selection key, select the channel number for which you want to
change the volume.
One control input can change one input or output channel volume.
You can change the sound volume for a channel even with the channel off, but not adjust it while monitoring
the sound.
IN1 – 8, OUT1 – 2, Max. OUT8 when T-001Ts are used (default: IN1) Setting Range
Set the volume level (dB) to increase or decrease.
0.5 – 10.0 dB (default: 0.5) Setting Range
(C52)
(When the control input function is set to CH ON)
C - I N 0 1 -> C H O N
(C53) Input/Output channel number selection
C - I N 0 1 - C H O N -> I N 1
[When the function is set to CH ON]
Assign the function to turn on the designated input or output channel to the control input terminal.
Closing the set control input terminal turns on the designated input or output channel.
Assigning a function to this terminal overwrites the previously set function on it if there is.
Select with the input or output channel selection key the input or output channel to turn ON.
One control input can turn on one input or output channel.
IN1 – 8, OUT1 – 2, Max. OUT8 when T-001Ts are used (default: IN1) Setting Range