Toa M-9000M2 v.2.00 - Manual (Page 37)

37
8.2.3. Cross point ON/OFF control using the remote controller
When the cross point ON/OFF function has been assigned to the buttons on the remote controller, sound
source to be output to the output channel can be selected by pressing the button.
Two control modes are made available for the cross point ON/OFF function: "EXCLUSIVE" and
"SIMULTANEOUS."
Note: Use the PC Setting software when performing remote controller settings.
[EXCLUSIVE MODE]
Only a single cross point can be selected so as to output a single sound source to the output destination.
In this mode, only a single cross point control can be assigned to each button on the remote controller.
This is a convenient function to always select and output only one sound source using the remote controller
installed at the output destination, which is ideal for individually selecting BGM or FGM sound source to be
output to each partitioned zone (output destination).
(Example) Using as a BGM selector
Assign Input 1, 2, or 3 (BGM source) to be routed to Output 1 to each button on one remote controller.
Likewise, assign the same input channel to be routed to Output 2 to each button on the other remote
controller. (Refer to the PC Setting software screens below.)