Toa M-9000M2 v.2.00 - Manual (Page 34)

34
8.2.2. Paging using the ZP-001T module
The ZP-001T's input is used as a paging input.
When making paging calls with the use of the ZP-001T, 3 operation modes are made available depending on
the setting.
AUTO: Automatically selects a single preprogrammed paging group when incoming call is received.
There is no need to select a paging zone.
MANUAL: Makes a paging call to the designated output with the telephone key operation (#1 - #8).
GROUP:
Selects one of 8 groups with the telephone key operation (#1 - #8).
Group settings must be performed in advance.
[Telephone paging in AUTO mode
In AUTO mode, when telephone paging is initiated, the paging call is made to the designated zones without
the need to select them. This mode is convenient when always making paging calls to the whole zone or
always to the preset zone(s).
Always makes telephone
paging to this zone.
Telephone paging
PBX
Backroom area
(Output channel 1) Sales area
(Output channels 2 and 3)
M-9000M2
Power amplifier
In this example, paging calls are made to the Output Channels 2 and 3 immediately after telephone paging
has been activated.