Toa M-9000M2 v.2.00 - Manual (Page 63)

63
(A17) Trigger setting
(for the channel on which the module
other than the ZP-001T is used)
(A17) Trigger setting
(for the channel on which the ZP-001T
is used)
P A G I N G T R I G C - I N P A G I N G T R I G Z P
(When the D-001T/R is used and the gate function is ON)
(A18) VOX threshold level setting
V O X - T H R E S H O L D - 3 0
(A19) Paging trigger control input terminal setting
P A G I N G T R I G N O N E
Sets the control input terminal to be used for paging trigger.
(A20) Paging interlock setting
P A G I N G S Y N C O N
Sets whether or not to activate the control output synchronizing with paging initiation.
(A21) Paging-interlocked output terminal setting
S Y N C O U T C - O U T 0 1 -
Sets the control output terminal to be activated when the paging-interlocked output is set to ON in the above
item. Select one of 1 through 12 using the setting knob, and set the paging-interlocked output to ON or OFF
using the output channel ON/OFF key.
Set the trigger to initiate paging. Type of trigger differs depending on the module that uses the channel.
• VOX: Voice Operated Switch
Enables paging if the audio input signal exceeds a preset level. (When the D-001T or D-001R is used)
When Trigger is set to VOX, be sure to also set the Gate function for the paging input channel to ON.
• C-IN: Enables paging while the control input terminal is closed.
• ZP:
Enables paging using the ZP-001T. (When the ZP-001T is used)
Modules except the ZP-001T, D-001T and D-001R: C-IN (default)
D-001T, D-001R:
C-IN (default), VOX, ZM
ZP-001T: ZP (default)
Setting Range
Set the input sensitivity to activate the gate function ( p. 41 "Glossary" ).
–40 to –5 dB (default: –30 dB), 5 dB steps Setting Range
NONE, CIN01 - 12 Setting Range
OFF (default), ON Setting Range
1 - 4 (12: when C-001T is used) , – (OFF: default), (ON) Setting Range
S Y N C O U T C - O U T 0 1 - S Y N C O U T C - O U T 0 1
When set to ON When set to OFF