P.83-c25), P.83-c22), P.83-c21) – Toa M-9000M2 v.2.00 User Manual
Page 83: P.83-c23), P.83-c24)
83
(C25) Lock status display
K E Y L O C K =
U N L O C K E D
The above screen displays the current key lock status.
When a key other than the Utility key is locked, "UNLOCKED" is indicated. If a locked key is pressed, the
display changes to the password entry screen. To enter the key lock setting flow, press the Enter key.
UNLOCKED (default), LOCKED
Setting Range
(C21) Remote-controlled channel setting
(when the remote controller type is set to VOLUME or ZM-9002)
R E M O T E 1 ->
O U T P U T 1
(C22) Communication type remote controller setting information
Z M I N F O R M A T I O N
Displays the setting of the ZM-9011/9012/9013/9014 Wall-mounted remote controller of data communication
type.
Note: This setting is made only by the supplied PC software.
(C23) Communication type remote controller ID/model number information
Z M I N F I D
0 1
=
9 0 1 1
Displays the connected remote controller and its ID number.
Note: This setting is made only by the supplied PC software.
(C24) Communication type remote controller function information
I D 0 1 S W
1
= L D B A N K 0 1
I D 0 1 V O L U M E = O U T 1
Displays the functions assigned to the buttons and/or volume control on the remote controller.
When the connected controller is ZM-9012 or ZM-9014 with a volume control, the output channel indicator of
the channel on the VFD lights to indicate that channel is assigned to the volume control.
The output channel selection indicator of the channel to be displayed by the level indicator flashes.
Select the input or output channel of which volume you want to remotely control by using the control input
terminals on the rear panel or ZM-9002's volume control.
The REMOTE 1 on the screen represents the REMT VOL 1 of control input terminal, and the REMOTE 2
represents the REMT VOL 2.
Use the Left and Right shift keys to move the setting items on the screen.
REMOTE 1, REMOTE 2
OFF, INPUT 1 – 8, OUTPUT 1 – 2,
Max. OUTPUT 8 when T-001Ts are used
(default for REMOTE 1: OUTPUT 1, REMOTE 2:
OUTPUT 2)
Setting Range
Remote Volume Terminal Number
Remote-controlled channel