YSI 5200A - Manual (Page 112)

YSI 5200A
223
YSI 5200A
222
Menu Maps

continued next page
Run Screen → Menus → Sensor Setup →
pH
pH (Enabled)
pH (Enabled)
Control Mode (Set Point)
�
Set Point
PID/PWM
Alarms (Disabled)
Alarm Low (8.10 pH)
0 to14.0*

Alarm Low (Disabled)
Alarm Low (Disabled)
Instrument (Local Machine)
Relay (Relay 1)
�
Relay 1
Relay 2
Relay 3
Relay 4
Set Point control only Range Low (8.20 pH)
8.2 to 14.0*

Range Low (Disabled)
Instrument (Local Machine)
Relay (Relay 1)
�
Relay 1
Relay 2
Relay 3
Relay 4
Dose Up (5 Sec)
1‐255

Time Units
�
Sec
Min Min
Hours
Dose Up Wait (15 Min)
1‐255

Time Units
�
Sec
Min
Hours
Set Point (8.30 pH)
8.30 to 14.0*

PID/PWM control only Control Up/Down (Rising)
�
Rising
Falling
Menu Maps
Run Screen → Menus → Sensor Setup →
pH continued from previous page
PID/PWM control only P.I.D. Interval (100.00)
1.00 to 999.90

PID/PWM control only P.I.D. Reset Interval (20.00)
1.00 to 999.90

PID/PWM control only P.I.D. Gain (2000)
0.00 to 10.00
1.00 to 999.90

PID/PWM control only P.I.D. Relay (Disabled)
Range Low (Disabled)
Instrument (Local Machine)
Relay (Relay 1)
�
Relay1
Relay2
Relay 3
Relay 4
Set Point control only Range High (8.40 pH)
8.40 to 14.0*

Range High (Disabled)
Instrument (Local Machine)
Relay (Relay 1)
�
Relay 1
Relay 2
Relay 3
Relay 4
Alarm High (8.50 pH)
8.50 to 14.0*

Alarm High (Disabled)
Alarm High Output enable/disable g p
Instrument (Local Machine)
Relay (Relay 1)
�
Relay 1
Relay 2
Relay 3
Relay 4
Set Point control only Dose Down (30 Sec)
1‐255

Time Units
�
Sec
Min
Hours
Dose Down Wait (15 Min)
1‐255
Time Units 
�
Sec
Min
Hours