YSI 5200A - Manual (Page 123)

YSI 5200A
245
YSI 5200A
244
Index
Conductivity
temperature compensation 146
timed and normal control 145
Conductivity calibration 77
Configuration chapter 65
Configuration log 106
contactor wiring. See Wiring contactor
Contact Us 240
Control board 40
Control menu 166
Control modes 132
PID/PWM control 138
PID/PWM control actions 139
PID/PWM Tuning 139
Set point control 134
Control value
timed control-conductivity 145
timed control range high temperature 151
D
Daily feedings (Feed Smart timer) 160
Daily weight (Feed Smart timer fcr) 161
Daily weight (Feed Smart timer-non fcr) 160
Data Logging menu 106
clear logs 108
event log 107
sensor log (data log) 106
Date and Time menu 109
Declaration of conformity 230
defaults. See Factory defaults
device timed out error. See Firmware Updater
DHCP (ethernet menu) 91
Display contrast 86
Display format (aux analog) 104
Display settings menu 111
DNS address (ethernet menu) 93
DO membrane 5561 35, 36
DO sensor calibration mg/l 81
DO sensor calibration % sat 79
DO sensor setup 147
Index
Dose time
conductivity control 145
pH control 150
Dwell time
conductivity control 145
pH control 150
E
Email addresses (ethernet menu) 93
Email alarming 88
5200A email 88
AquaManager email 88
email retry delay 99
send test email 98
Ethernet menu 90
DHCP 91
DNS address 93
email addresses 93
gateway 92
IP address 92
port 93
subnet mask 92
Ethernet module
configure communications ethernet menu 90
event log error message 94
installation 60
SMS messaging 95
Event logging 107
Event log view 168
Explorer window - AquaManager 174
F
Factory defaults 201, 202–254
fcr (feed timer) 160
Feed Smart Timer 157
biomass 161
calibrate 163
daily feedings 160
daily weight 161
fcr