Luxul XMS-1024P - Manual (Page 132)

132
XMS-1024P
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XMS-1024P Vers: 081314
Create Static Multicast
Search Option: Select the Rule for displaying Multicast IP table to find the desired
entries quickly.
„
All: Displays all static Multicast IP entries.
„
Multicast IP: Enter the Multicast IP Address the desired entry contains.
„
VLAN ID: Enter the VLAN ID the desired entry contains.
„
Port: Enter the Port number the desired entry contains.
Static Multicast IP Table
Select:
Select the desired entry(ies) to delete the corresponding static
Multicast IP.
Multicast IP: Displays the Multicast IP.
VLAN ID: Displays the VLAN ID of the Multicast Group.
Forward Port: Displays the Forward Port of the Multicast Group.
CAUTION: Static Multicast IP settings will be restored to defaults if the
Switch is restarted and you have not selected Save Config from
the main menu and saved your running configuration to non-
volatile memory.
8.3 Multicast Filter
When IGMP Snooping is enabled, you can specify the Multicast IP-Range the Ports can
join to restrict client devices ordering Multicast programs by configuring Multicast
Filter Rules.
When applying for a Multicast Group, the client device will send an IGMP Report
Message. After receiving the Report Message, the Switch will check the Multicast
filter Rules configured for the receiving Port. If the Port can be added to the Multicast
Group it will be added to the Multicast MAC Table. If the Port cannot be added to the
Multicast Group the Switch will drop the IGMP Report Message. Multicast streams will
not be transmitted to this Port. This allows you to control client devices able to join a
Multicast Group.
8.3.1 Multicast IP-Range
On this page you can figure the desired IP-Ranges to be filtered.