User guide – Luxul XMS-1024P User Manual
Page 47
47
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
Loopback Detection
Loopback Detection: Enable or Disable Loopback Detection globally.
Detection Interval:
Set a Loopback Detection interval between 1 and 1000 seconds the
default value is 30 seconds.
Automatic Recovery: The amount of Time after which the blocked Port will automatically
return to normal status. It is set as a number of detection intervals to
elapse before Automatic Recovery.
Refresh Status:
Enable or Disable automatic refresh.
Refresh Interval:
Set a web refresh interval between 3 and 100 seconds the default
is 3 seconds.
Port Config
Port Select:
Enter a Port number and click the Select button to quick-select the
corresponding Port.
Select:
Check the check box of the desired Port(s) for Loopback
Detection configuration.
Port:
Displays the Port number.
Status:
Enable or Disable Loopback Detection for the Port(s).
Operation Mode:
Select the Mode the Switch will operate in when loops are detected.
Alert: When a loop is detected display an alert.
Port based: When a loop is detected display an alert and block
the Port.
Recovery Mode:
Select the Mode the Switch will use to unblock Ports marked for
recovery to normal status.
Auto: Block status can be automatically removed after
Recovery interval.
Manual: Block status only can be removed manually.
Loop Status:
Displays if a loopback is detected.
Block Status:
Displays the Port Blocking Status block or unblock.
LAG:
Displays the LAG Group number the Port belongs to.
Manual Recover:
Click to Manually remove the block status of selected Port(s).
CAUTION: Loopback Detection settings will be restored to defaults if the
Switch is restarted and you have not selected Save Config from
the main menu and saved your running configuration to non-
volatile memory.