AGI Security SYS-HC0451S2 - Manual (Page 180)

170
4.10.4.2 HDD Manager
Here is for you to view and implement hard disk management. See F igure 4-111.
You can see current HDD type, status, capacity and etc. The operation includes for mat HDD, and
change HDD property (read and write/read-only/redundancy).
Figure 4-111
4.10.4.3 Record
4.10.4.3.1 Record Control
Caution:
You need to have proper r ights to implement the following operations. Please make sure the HDD
has been properly installed.
There are three ways for you to go to manual record menu.
 Right click mouse and then select Manual->Record.
 In the main menu , from Setting->Storage->Record.
 In live viewing mode, click record button in the front panel or record button in the remote cont rol.
System supports main stream and sub stream. There are three statuses: schedule/manual/stop. See
Figure 4-112. Please highlight icon“○” to select corresponding channel.
 Manual: The highest priority. After manual setup, all selected channels will begin ordinary recording.
 Schedule: Channel records as you have set in recording setup ( Main Menu->Setting->System-
>>Schedule)
 Stop: Current channel stops recording.
 All: Check All button after the corresponding status to enable/disable all-channel schedule/manual
record or enable/disable all channels to stop record.