AGI Security SYS-HC0451S2 - Manual (Page 232)

222
Parameter Function
Show
message System can pop up a message to alarm you in the local host
screen if you enabled this function.
Buzzer Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
Alarm upload System can upload the alarm signal to the centre (Including alarm
centre.
Message When 3G network connection is OK, system can send out a
message when motion detect occurs.
Send Email If you enabled this function, System can send out an email to alert
you when an alarm occurs.
Tour You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs.
PTZ
Activation Here you can set PTZ movement when alarm occurs. Such as go
to preset X. See Figure 5-54.
5.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-55.
After analysis video, system can generate a video loss alarm when the detected moving signal reached
the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest setups, please
refer to chapter 5.8.3.1.1 motion detect for detailed information.
Figure 5-55
5.8.3.1.3 Tampering
The tampering interface is shown as in Figure 5-56.
After analysis video, system can generate a tampering alarm when the detected moving signal reached
the sensitivity you set here.
For detailed setups, please refer to chapter 5.8.3.1.1 motion detect for detailed information.