Compuprint MDP40B Programmer Manual - Manual (Page 103)

A-101
Only the selection of Draft/Quality printing, DDL and the selected character generator
are maintained.
ESC [ K
Sets initial conditions. (IBM 2391+, 9068)
ASCII Code ESC [ K n
1
n
2
init id
Hexadecimal Value 1B 5B 4B n
1
n
2
init id
Decimal Value 27 91 75 n
1
n
2
init id
This command causes the printer to reset to its initial status:
n
1
and n
2
The n
1
and n
2
parameters specify the number of bytes in the escape sequence
normally, n
1
= 2 and n
2
= always 0.
init The init parameter specifies to which condition the printer should initialize,
normally init = 0,1,4,5,254,255:
0 Initializes printer to user-default settings. The download font remains
unchanged. If parameters are specified, they will overwrite the default
settings. If the emulation mode is changed, the download font will be
initialized. This command will only copy data from the selected macro, add
parameter changes, if any, and store in working RAM; the data stored in
the macro’s non-volatile RAM will not be affected.
1 Initializes printer to user-default settings. The download font is initialized. If
parameters are specified, they will overwrite the default settings. This
command will only copy data from the selected macro, add parameter changes,
if any, and store in working RAM; the data stored in the macro’s non-volatile
RAM will not be affected.