Compuprint MDP40B Programmer Manual - Manual (Page 48)

A-46
m
3
Character Height Line Spacing
0 No change No change
1 Standard character height Line feeds unchanged
2 Double character height Line feeds unchanged
16 Character height unchanged Normal line feeds
17 Standard character height Normal line feeds
18 Double character height Normal line feeds
32 Character height unchanged Double line feeds
33 Standard character height Double line feeds
34 Double character height Double line feeds
m
4
specifies the character width. Only the low-order half-byte is significant in this
mode byte. The high-order half-byte is ignored.
m
4
Character Width Line Spacing
0 No change No change
1 Standard width character No change
2 Double width character No change
ESC [ d
Set the print quality. (IBM 2391+)
ASCII Code ESC [ d 1 0 n
Hexadecimal Value 1B 5B 64 01 00 n
Decimal Value
27 91 100 1 0 n
This command sets the print quality to draft or LQ print. See the following table: