Compuprint MDP40B Programmer Manual - Manual (Page 131)

B-24
0x02 Ratio of the dimensions between the defined large and the small bar,
one parameter:
B Ratio multiplied by 10 (dimension of the large bar =
((b/10) * (B/10)) mm), where 20 < B < 40
0x03 Dimension of the small bar, one parameter:
b Dimension of the small bar in 1/100 mm, where 20 < b < 255
0x04 Dimension of the white space between a symbol and the following,
one parameter
i Dimension of the white space in 1/100 mm, where 20 < i < 255
0x05 Dimension of the maximum retries in case the bar code was not read
correctly, one parameter: 0 < rn < 10
0x06 Offset from initial position, to be used in case of retry. One parameter:
rof 0, 2 < rof < 20. The offset is set in 1/10 mm. When using the
horizontal scanning, the offset will be used starting from the y
position, when using the vertical scanning, the offset will be
used starting from the x position. For example, for the
horizontal scanning:
• The first retry is performed in position (y+1*(0,1*rof)) mm
• The second in position(y-1*(0,1*rof)) mm
• The third in position(y+2*(0,1*rof)) mm
• The fourth in position(y-2*(0,1*rof)) mm, etc.
All parameters, except the options parameter, are optional. If they are not specified,
they are set to their default values, which are the following:
x 10 mm
Y 10 mm
W 100 mm
t
1
…t
n
Empty list, all types are accepted
B 25