Compuprint MDP40B Programmer Manual - Manual (Page 204)

C-62
ESC \
Record and check magnetic stripe. (Olivetti PR2, PR40+, 2845)
ASCII Code ESC \
Hexadecimal Value 1B 74 data 1D
Decimal Value 27 116 data 29
Records the data sent by ESC t data GS and is considered the end of data.
If the document is not inserted, the printer feeds it in.
The command is not accepted (command specification error) if it is not preceded by the
ESC t data GS command
If, at the end of the recording, errors are found during the check, the answer to the
status request will indicate a record or check error ESC r q.
Since after the execution of the command the position of the document is unknown, its
subsequent positioning must be given as an absolute position.
ESC Y E
Set horizontal magnetic device. (Olivetti PR2, PR40+)
ASCII Code ESC Y E k
1
k
2
Hexadecimal Value 1B 59 45 k
1
k
2
Decimal Value 27 89 69 k
1
k
2
When the command is received, the device takes on the configuration indicated by
parameters k
1
and k
2
.