Compuprint MDP40B Programmer Manual - Manual (Page 11)

A-9
ESC ]
Sets a reverse line feed. (IBM 2391+, 4722, 9068)
ASCII Code ESC ]
Hexadecimal Value 1B 5D
Decimal Value
27 93
This code is a terminator code; when received, it causes the current contents of the
print buffer to be printed out, before reversing the paper by one line at the current
vertical spacing. If no data precedes this command or if the preceding data consists of
spaces, the code causes only a reverse line feed to be performed. When the line counter
is equal to or less than the top of the form value, the ESC ] is ignored.
ESC 5
Sets an automatic line feed after a carriage return.
(IBM Proprinter XL24/XL24E, 2391+, 4722, 9068)
ASCII Code ESC 5 n
Hexadecimal Value 1B 35 n
Decimal Value
27 53 n
If n is equal to 1, this command sets an automatic line feed on receiving of a CR code.
If n is equal to 0, this command cancels the automatic line feed.
n Automatic line feed
0 Disabled
1 Enabled