Hypertherm Powermax45 Service Manual - Manual (Page 98)

TroubleshooTing and sysTem TesTs
5-22
powermax
45 Service Manual
Test for 400 V Ce power supplies
For this test, you can use the test point loops or you can test on the capacitor screws. The test points are labeled on the
back of the power board, as are the voltages and positive and negative capacitor terminals.
CAUTIoN
To test using the test points, do not use a multimeter with test probes. Use e-Z Hook leads instead
and attach them to the test point loops.
1. Turn OFF the power.
2. Position the multimeter leads to measure the voltage on the power board by attaching the test leads with the
negative lead on TP 17 and the positive lead on TP 16. Turn on the power. The multimeter should read 560 VDC.
If you get a value other than 560 VDC, multiply the reading by 0.00601. Compare that value to a reading at pin 21
on J8. They should have the same value.
3. Attach E-Z Hooks to TP (test point) 17 and TP 18. Turn the power ON after you have connected the multimeter.
This value should be 280 VDC or one-half of whatever value you found in step 2.
Note: All values can be ±10%.
4. Turn the power OFF and move the E-Z Hooks to TP 18 and TP 16. Turn the power ON after you have connected
the multimeter. This value should be 280 VDC or one-half of whatever value you found in step 2.
5. The values found in steps 3 and 4 should be approximately equal. If they differ by more than 30 V, replace the
power board.
TP17
W
+ - + -
TP18
B
TP16
R
~280 VDC ~280 VDC
TP17
W
+ - + -
TP18
B
TP16
R
~280 VDC ~280 VDC
Step 2
Step 4
Step 3