Rena T-950 - Manual (Page 11)

GETTING ACQUAINTED
5
Entrance End View
1 Media Sensor 1 – This sensor detects the media (mail piece).
Note: To accommodate the ability to run media down the front or back of the tabber;
there are two media sensors in the tabber. Sensor 1 is mounted near the Operator
Control Panel side (front) of the tabber, as shown. Sensor 2 is mounted opposite sensor 1
on the Non-Operator side (rear) of the tabber.
Please be sure the appropriate sensor has been selected in the Setup Menu.
2 Registration Assembly – Contains Guide Rollers that help align the media against the
Media Guide Fence.
3 Media Guide Fence (Front) – As the media feeds, it must be held against this fence to
achieve proper tabbing performance.
Note: To accommodate the ability to run media down the front or back of the tabber;
there are two Media Guide Fences in the tabber. One is located at the front of the tabber
(operator side) and one is located at the back.
4 Media Hold-down Guides & Securing Knobs – These guides are used to hold the
media against the transport belts as it feeds through the tabber. One guide is normally
positioned very close to the Media Guide Fence and the other guide is normally
positioned near the opposite edge of the media.
5 Registration Guide Roller Adjustment Knob - Used to change the angle of the
registration guide rollers, in order to push the media against the Media Guide Fence.
6 Registration Assembly Securing Knobs – Used to secure the position of the
Registration Assembly to the tabber.
7 Short Media Hold-down Guide – When needed, this guide can be positioned to
provide additional assistance to hold the media against the transport belts.
1
7
2
4
3
6
5