Rena T-950 - Manual (Page 53)

SETUP & OPERATION
47
6. Select the # 2 soft key to select two tabs.
Press the Length soft key to set the media
length.
7. Make sure the transport power button is on then
press the Automatic soft key.
If instructed to increase or decrease transport
speed, do so until the message “Feed 1 Product
now. Appears”.
8. Feed 1 Product (one piece of media).
The tabber will measure the media length and
display this information.
Verify that the measured length is accurate
(+ or - 0.250” of actual piece length).
Once you have an accurate measurement, you
can press the EXIT soft key to proceed to the
next step.
Tip: If the tabber measures the piece to be longer then the actual piece length; then more than one piece
may have been fed, or the media may be slipping or hesitating as it feeds. Check/Adjust the transport
system.
If the tabber measures the piece to be shorter than the actual piece length; then the media may not be
feeding straight (missing the sensor), or a hole in the media may be traveling through the sensor, or the
sensor may be getting reflection off the mail piece. If using a high gloss media; the sensor intensity may
need to be adjusted lower, by a qualified Rena service person.
If the media passes through without the tabber providing a measurement; then the wrong media sensor may
have been selected, or the media sensor may be dirty. Check to be sure the correct media sensor was
selected. Try cleaning the sensor as described in this manual.
These problems need to be corrected before the tabber will function correctly.
9. Press the Backing soft key.
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
# Tabs Length Backing EXIT
Enter piece length and press SAVE key
0.0” Current value: 9.546”
Automatic EXIT
Enter piece length and press SAVE key
0.0” Current value: 8.523”
Status: Pieces: 1
Automatic EXIT
Select option to edit, or
Press RUN to tab using Job 2.
Status:
# Tabs Length Backing EXIT
Press 1, 2 or 3 for the number of tabs.
Current value: 2
Status: Job Setup
1 2 3 EXIT