Rena T-950 - Manual (Page 56)

SETUP & OPERATION
50
Applying a Single Stamp
When applying a single stamp to an envelope the TABBER is setup the same as described for
tabbing, except for the following:
 Select # Tabs as 1.
 When using the Auto Tab/Stamp
Positioning mode, you need to select
Stamp Fwd, if you are applying a stamp to
the trailing edge of the mail piece; or
Stamp Rev, if you are applying a stamp to
the leading edge of the mail piece.
 When using the Manual Tab/Stamp
Positioning mode, you will need to set the
position of the stamp, using the Offset
feature.
Enter the desired offset value for the
stamp, using the numeric keypad, then
press the SAVE button.
Note: When using stamps, the Backing
type should be set to opaque.
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
Tab Stamp Fwd Stamp Rev EXIT
Press 1, 2 or 3 for the number of tabs.
Current Value: 1
Status: Job Setup Pieces: 0
1 2 3 EXIT
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
# Tabs Offset Backing EXIT
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
# Tabs Offset Backing EXIT
Enter tab offset 1 and press SAVE key:
0.0”
Current Value: 0.250”
Status: Job Setup
EXIT