Rena T-950 - Manual (Page 13)

GETTING ACQUAINTED
7
Control Panel
1. MAIN POWER SWITCH – Turns power to the tabber ON and OFF.
2. HEAD POWER SWITCH – Turns the power on to the Tab/Label motor.
3. TRANSPORT POWER SWITCH – Turns the tabber transport power ON and OFF.
4. JOG SWITCH – Permits the operator to jog or move the transport slowly for setup
purposes.
5. SPEED CONTROL – Adjusts the speed of the tabber.
6. LCD DISPLAY – Keeps the operator informed of the status of the tabber.
7. KEY PAD – Used to set the adjustments and program the tabber
8. EMERGENCY STOP BUTTON –When pressed, this button will shut down the tabber
and any other units that are connected to the Emergency Stop circuit. Turn the button
clockwise to release. The tabber and all connected units will need to be powered back on.
9. SOFT KEYS – The soft keys are used to step through the various menu options to
program the tabber.
10. STOP KEY – Pressing this key will stop the tabber and hold it in a ready state to resume
operation.
11. RUN KEY – Pressing this key to start the tabber when running a job.
12. INFO KEY – Pressing this key will change the display to the information mode.
13. SAVE KEY – This key is used to save the entries into the memory.
14. CLEAR KEY – This key will clear any incorrect entry before it is saved in the memory.