Rena T-950 - Manual (Page 58)

SETUP & OPERATION
52
Running a Pre-Programmed Job
Up to four jobs may be programmed into the TABBER memory.
To run a pre-programmed job:
1. Turn on the tabber using the Main Power Switch, located on the left side of the
TABBER.
2. Check that the Emergency Stop switch is in the operate position.
3. Press the Green Transport Power switch on the TABBER Control Panel.
4. Press the Mode soft key.
5. Press the Job # soft key.
6. Select the Job you wish to run.
In our example, we are selecting Job # 2
using the soft key 2.
After pressing the soft key, the screen to
the right will appear.
Press the EXIT key twice to return to the
Start-up screen.
Select program mode Job# or Automatic.
Status: Mode
Job# Auto Pos. EXIT
Select Saved Job# (1-4), or
Press RUN to tab using Job 1
Status: Job #
1 2 3 4
Press RUN to tab using Job 1.
Status: Pieces: 0
Mode Tab Jog Pass-Thru Advanced
Press RUN to tab using Job 1.
Status: Pieces: 0
Mode Tab Jog Pass-Thru Advanced
Select option to edit, or
Press RUN to tab using Job 2.
Status: Job Setup
# Tabs Offset Backing EXIT